Just changed a clutch and now have issues??

I just did the clutch in my 2001 Hyundai Accent, and it is not working correctly. I did everything correctly, according to the book, but am having a slight issue. When shifting from neutral to 1st or 2nd, the pedal has to be in a very specific spot, about an inch from the floor to go in. If its to the floor, it wont go into gear. Driving 1 through 5 is fine, but when I go to downshift, it has to be at a very low RPM or else it grinds. What could be wrong? Hydraulic system is good with no leaks, no noises or clutch smell, etc. Thanks!
Just changed a clutch and now have issues??
are you sure you put the clutch disc in the right way around?

you could try bleeding the slave cylinder, but i don't think its your problem.
Just changed a clutch and now have issues??
Did you change the release bearing as well? The release bearing %26quot;sometimes called a 'throw-out' bearing will cause the issue you are have .
check you slave cylender
I'm guessing that you did a complete clutch job , you did replace the pressure plate , clutch , throw-out bearing and the pilot bearing. I'm sure that it as a salve cylinder as well , it maybe that you just don't have all the air bleed out of the line, i had this problem where i throught i had all the air out of the line , but the more i drive it the better the clutch got , so maybe that your problem and the more you drive the better it gets.

view myspace

horses