How do you change a clutch hydraulic line on a 1995 1500 Chevy?

I need help|||pretty straight forward....remove the hydraulic line from the clutch master...usually attached with a flare nut..you should use a flare nut wrench...then remove the other end from the slave cylinder...replace the line , tighten the nut,s properly , fill the master with D.O.T.3 brake fluid , open the bleeder valve at the slave cylinder , have an assistant depress the clutch pedal , close the bleeder valve before the pedal is released, repeat this process untill all the air is removed...be sure to top off the master between bleeding attempt,s , you may need to extend the travel from the slave cylinder to the clutch control arm to achieve proper release operation...check to insure there are no leak,s...good luck!...P.S....you may e-mail if you have a problem...I hope I have explained well enough.